Plant Integration using the example of AVEVA 3D
UNITEC makes data transfer in AVEVA 3D possible
Data Transfer from AutoCAD
A client of an engineering firm requires project data to be delivered in the AVEVA 3D format. However, the service provider uses AutoCAD and is therefore unable to supply the requested format. Transferring the design data in a conventional format—such as MicroStation DGN—is not a viable option, as critical geometries would be reduced to wireframes lacking full shading, rendering them unsuitable for clash detection or the generation of 2D drawings.
Data Transfer from MCAD
In principle, UNITEC offers data transfer into AVEVA Plant based on 3D primitives and surfaces. If—as in this case—no B-Rep (Boundary Representation) model is available, conversion can instead be performed using tessellated geometries. A drawback of this approach is that the model becomes very cumbersome, and any generated drawings contain an excessive number of lines. Another option provided by AVEVA is STEP referencing, which allows for faster visualization of the model; however, this method does not support taking measurements or modifying the geometry (e.g., moving or deleting components).
UNITEC proposes a combination of both technologies as the optimal solution.
Advantages of Our Conversion Solution
Rather than taking on the unpredictable risks associated with acquiring a new system and developing the necessary in-house expertise, the client can utilize UNITEC’s intelligent interface for AVEVA E3D/PDMS. This allows the team to continue working within their familiar source system, followed by an intelligent transfer of data into the target system. Our conversion service is offered under attractive "pay-per-use" terms. We look forward to receiving your inquiry.
Products Used
UNITEC AVEVA E3D/PDMS Interface (no AVEVA license is required for the conversion process)